Research labs

"I'm ready to see the research labs now," you said to MPAD-24.

In response, the robot began floating down the hallway while describing aspects about the labs. "There are eight research labs on this level. Four of these are dedicated to probe research. Two labs are currently being used for Feeler research. One lab is being used for chemical analysis of recently visited worlds. The other lab is currently unused.

Seriously? Half of their research labs were being used for probe research? On the other hand, that wasn't all that surprising considering how fond the Grey doctor was for using the probes in the medical bay.

"Let's start with the Feeler labs," you said. After eating one of their seeds, you were curious to see what they looked like.

MPAD-24 floated down a corridor and turned. Once there, the robot moved toward the wall, and a section of it became transparent, allowing a view of what was inside the lab. The room reminded you of a greenhouse, and within it there were multiple plants, but the large green vines in the middle looked somewhat ominous. You could see how they might blend in well with other vegetation, but having seen this one, it would be a lot easier to spot another.

"Is it dangerous?" you asked.

"The Feelers are pruned daily to keep them docile, and to ensure they are safe to handle. Would you like to enter the lab to see it up close?"

"No thanks," you replied. "I was just interested in seeing what it looked like in case I encounter one."

"Which lab would you like to see next?" asked MPAD-24.

There didn't seem to be much point to seeing the empty lab, the chemical analysis or the other Feeler lab which left the probe labs. Having experienced a few of their probes, you were curious about just how sick and twisted the Greys must be that designed, developed and tested them in the first place. Maybe you'd be better off not knowing, but you were here, so you might as well check it out. "Show me one of the probe labs."

"According to the schedule, tests are currently in progress in probe research lab two. Would you like to observe?" inquired MPAD-24.

"Sure," you replied, and then you followed the floating robot down another corridor before it moved toward the wall and a section became transparent. As you looked in, you could barely believe what you were seeing. Three seemingly identical blond Cunis were positioned on metal tables like the ones in the medical lab. Each of the bunny girls was in a similar contorted position with their ass up in the air and their head and shoulders down against the table. Their knees were also down on the table on each side of their head with their feet pointed toward the window while their arms were held down and pointing the opposite way. Restraints in the table held their waist, legs and arms in place. Meanwhile, each of them had a large tube inserted into their anus which was connected to a device near the ceiling. The three tubes were each glowing a slightly different color and wiggling at a different rate while the three Cunis seemed to be writhing in varying degrees of pleasure as a result.

As you watched, you had a perfect view of their glistening vaginas, shiny from their love juices that were leaking out during the testing. You immediately felt your dick begin to get hard again, but you tried to stay focused. "Can you tell me more details about the testing and these test subjects?"

MPAD-24 promptly began to explain with its monotone voice. "The current procedure is a vibration test to characterize measurements from a new anal probe design at different oscillating frequencies. This is to ensure that the new probe design can maintain accurate readings from the subject in case of sudden voluntary or involuntary movements. The three subjects are five-year-old Cuni triplets named Daisy, Jasmine and Shasta. Their identical physiology makes them ideal subjects for side-by-side comparison tests."

"Why are they positioned this way?" you asked. It looked awkward, and maybe even painful to be in that position for very long.

"The subjects have been placed in the optimal position for safe probe removal, which reduces the the chance of probes becoming stuck inside the subject, and it also minimizes the chance of damage to the probes or relay tubes," stated MPAD-24. "The current test will complete in two minutes, and then the probes will be removed. Would you like to continue viewing the test?"

"Definitely," you blurted out. "I never realized probe testing would be so interesting to watch." They could probably make a ton of money selling spectator seats for this sort of thing.